I bought the official website of the device Fortin EVO-ALL and programmer for it. When connecting I have a problem . The problem occurs in the first step when power to the device , namely the black (ground) and the red cable ( +12 ) . I followed the instructions , squeezed the button on the device and connect the power connector ( black connector) . After connecting the flashing LEDs in the following order : blue, yellow, red , yellow , blue + red, and then blue, yellow, red , yellow , blue + red, etc. According to the instruction sequence indicators should flash sequentially. I can not understand what it is, after all only connected power .
Despite this, I continued connection . Follow step 2, 3 , 4 ( the behavior of the indicators consistent with instructions) and step 5 again discrepancy after clicking on the Push-to-Start tanned just two yellow + red LED . What am I doing wrong?
My car Chevrolet Cruze 2013 Push-to-Start.
Connecting the wiring instructions. I downloaded the instructions from the official site
https://ifar.ca/download/11511/evo-all_buick_regal_pts_%282013%29_cruze_lacrosse_pts_%282010-2013%29_cadillac_srx_pts_%282010-2013%29.rev-20131004.pdf
EVO-ALL Service # 001A06 250124
My account
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Find Our Products 
Order Our Products Online
Find an 
